Installation
Installation is done in 3 steps. It is recommended that 2 people be available for installation. We suggest consulting a local expert if you are unfamiliar with masonry assembly and installation. Treat mantels like glass until they are installed. Once they are mounted the mantels strong and sturdy.
3 Step Installation:
Masonry installation: Install corbels onto the masonry by attaching the brackets with 3/8” x 4” lag screws using suitable anchors. You will need 2 per corbel. For even weight distribution of the shelf, mount corbels approximately 12” in from each end on the 5 ft. shelf and 18” on the 6 ft. shelf. After corbels are installed, apply mortar or construction adhesive, per manufacturer’s product instructions, to the top of each corbel and to the back of the shelf. Set mantel on top of corbels, arrange so that it is centered on the corbels and press against the wall. If necessary, clean with a slightly dampened cloth. Commercial cleaning products are not recommended. If this is new construction, the stone will go over the brackets keeping them out of sight.
If this is a retrofit, use any stone parts that were chipped out in order for the shelf to fit to hide the brackets. If installing to drywall, it will be necessary to cut the drywall away and install additional blocking between the studs to support the weight of the corbels and shelf. Hide the corbel brackets when reinstalling the drywall or hide with whatever material you may be using over the drywall (i.e. stone veneer, tile, etc.).
If necessary, please consult a professional.
Each mantel is hand crafted. To insure a secure fit for the mantel and brackets we advise you to install the mantel shelf and corbels first. Then, install the stone around the shelf. Measurements may vary by 1/2” because each mantel is hand-crafted and poured.